Lifting Bridge...
Posted: Sun Oct 03, 2021 6:00 pm
Hi,
I just noticed a very slight gap on the back of the bridge on my ~2018 D1A. The thickest I could get under it was with some paper that measures ~.006" thick. It went under ~1/8". I can't figure out how to add photos.
Humidity has been steady 40-50% and it's been cased more than played by far. Sounds fantastic!
I recall on Martins they didn't strip the finish from the entire bridge footprint so they would often "lift" with RH changes and not coming undone per se.
How concerned should I be?
I guess I should contact Collings...
Thanks,
Trav
I just noticed a very slight gap on the back of the bridge on my ~2018 D1A. The thickest I could get under it was with some paper that measures ~.006" thick. It went under ~1/8". I can't figure out how to add photos.
Humidity has been steady 40-50% and it's been cased more than played by far. Sounds fantastic!
I recall on Martins they didn't strip the finish from the entire bridge footprint so they would often "lift" with RH changes and not coming undone per se.
How concerned should I be?
I guess I should contact Collings...
Thanks,
Trav